Filter
Top Products
11
Carefully drive out the tool spring pin.
Push the tool set pin up and out of the front
cap using a screwdriver or round bar.
Note: Check Table 1, Page 10, before handling
tools.
For models HH100 through HH750-2,
manual removal is possible.
For hammer models HH1000-2 and larger
use hoist and sling as shown. Check for
sling load rating and compare to
Table 1, Page 10.
• When installing the tool in the hammer,
reverse steps 1 through 4 above. Note that
tool spring pin must be inserted with the
slot or open side away from the tool set pin.
Figure 4. Tool Replacement
4
60
o
1/3
1/3 1/3
SLING ANGLES
NOT SMALLER THAN: