Filter
Top Products
VGM, VGD-0505
10
hot water.
2. Rinse with hot water, but do not flood.
3. Apply the sanitizing solution according to
Hussmann’s directions.
4. Rinse thoroughly.
5. Dry completely before resuming operation.
CLEANING GLASS & MIRRORS
Only use a soft cloth and mild glass cleaner for cleaning
any glass or mirrored components. Be sure to rinse and/
or dry completely. Never use hot water on cold
glass surfaces! It may shatter and cause serious
injury! Allow glass surfaces to warm first.
CLEANING
PRECAUTIONS
WHEN CLEANING:
Never Use a Cleaning or Sanitizing
Solution that has an OIL BASE
(these will dissolve the butyl
sealants) or AMMONIA BASE (this
will corrode the copper components
of the case)
TO PRESERVE THE ATTRACTIVE FINISH:
Do Use Water and a Mild Detergent for
the Exterior Only!
Do Not Use Abrasives or Steel Wool
Scouring Pads (these will mar the finish)
NON-GLARE GLASS
The high optical clarity of this glass is possible due to
special coatings on the glass surface itself. To preserve
this coating and the optical clarity, keep th glass clean.
Windex® or Glass Plus® are the only soluitons recom-
mended to be used to clean the non-glare glass. The
damage to the glass from improper, cautic solutions is
irreparable.
In addition to cleaning the glass with the recommended
product, there are precautions that should be taken
when working and cleaning the inside of the case.
• When cleaning the inside of the cases, we
recommend tha tthe glass be fully opened and
covered to prevent to prevent solutions from
plasihgn onto the glass and ruining the coating on the
inside.
PLEXIGLASS & ACRYLIC CARE
Improper cleaning not only accelerates the cleaning cycle
but also degrades the quality of this surface. Normal daily
buffing motions can generated static cling attracting dust
to the surface. Incorrect cleaning agents or cleaning
cloths can cause micro scratching of the surface, causing
the plastic to haze over time.
CLEANING
Hussmann recommends using a clean damp chamois, or
a paper towel marked as dust and abrasive free with
210
®
Plastic Cleaner and Polish available by calling
Sumner Labs at 1-800-542-8656. Hard, rough cloths or
paper towels will scratch the acrylic and should not be
used.
ANTISTATIC COATINGS
The 210
®
has proven to be very effective in not only
cleaning and polishing the Plexiglass surface, but also
providing anti-static and anti-fog capabilities. This product
also seals pores and provides a protective coating.