Filter
Top Products
Rev. 0505
5
6. Slide second case up to first case snugly. Then level
second case to the first case so glass front, bumper
and top are flush.
7. To compress silicone at joint, use two Jurgenson
wood clamps. Make sure case is level from front to
back and side to side on inside bulkheads at joint.
8. Attach sections together via a 3 bolts located in the
base of the case. Secure the overhead structure by
bolting the rear mullions tegether.
Do not use bolts
to pull cases together!
9. Apply bead of silicone to top of bulkheads and slip on
stainless steel bulkhead cap. Also apply silicone to
seam between overhead light tubes.
10. VERY IMPORTANT! Apply liberal amounts of
black silicone to area under interior lower legs and
fill all voids down to bulkhead.
11. Use finger to smooth silicone as thin as possible at
masking tape on inside and outside of rear mullion
(apply additional silicone if necessary). Remove tape
applied on line #3.
BOLT
SEALANT
BOLT
Figure 2
DO NOT SEAL JOINT TRIM TO FLOOR!