Filter
Top Products
RECOMMENDED POWER AIR INLET SYSTEM
M105
40
Your ARO self-feed tool is designed to deliver specific horsepowerand thrust to achieve high rates of work. To assure the unit will develop this
power, care must be taken that the power air Inlet system Is correctly sized to permit the proper rate of air flow. Shown above is a system for a
single tool that will supply correct dellvery.
IMPORTANT: The tool is power-rated when 90 p.s.i. is present at the tool during operation. To check operating air pressure at the tool, a pressure
gauge may be installed in a 1/8” n.p.t. port marked “Auxiliary Supply”. CAUTION: This port Is pressurized when tool Is connected to air supply.
Shown below Is the same system in schematic form.
If two units are to be Installed, each unit should be supplied with a system like that shown below or use two systems Iike that above.
15