Filter
Top Products
16
If you removed a processor from the socket in a prior step, refer to the sketch
you made in Step 4 for proper orientation of the Pentium OverDrive processor.
No force is required for the pins to fit into the pin holes. Close the socket by
moving the handle down. Very little force is required to close the socket lever.
Do not use excessive force. Your computer’s system board should NOT bend
under the pressure.
PC-2643
Push handle to lock
In a socket with no handle:
Place the Pentium OverDrive processor into the socket, making sure to match
the corner with the blunt edge and distinctive pin arrangement to the socket
corner containing the key pin hole. If your socket does not have a key pin hole
corner, refer to the sketch you made in Step 4 to orient the Pentium OverDrive
processor correctly.
Seat the Pentium OverDrive processor in the socket by pressing firmly and
evenly on the key pin corner and the opposite corner at the same time. Be sure
to avoid pressing on the center of the fan and on the corners containing the
release clips and assembly connector.
DO NOT apply pressure to the center of the fan or corners
containing release clips and contact pins.
TM
Push here only
Push here only