Filter
Top Products
7
To install the software on your hard disk, insert the diskette in drive A and:
For DOS users type: a:\install
e
For OS/2* or Windows NT*
users type from a DOS prompt: a:\install
e
For Windows users: In the Program Manager, select: FILE
and then select: RUN
On the Command Line, type: a:setup
and click OK
For Windows 95 users: From the task bar, select Start
From the Start menu, select Run
and at the prompt type:
\SETUP
To begin the demonstration after installing the software:
For DOS users: Go to the odp_util directory and type:
overdriv
e
For Windows NT users : Go to the odp_util directory and
type
from a full-screen DOS prompt:
overdriv
e
For Windows users: Double click the icon “OverDrive
Processor Demo/Diagnostics”
For OS/2 users: Ensure that the following line ap-
For more information, pears in your config.sys file:
refer to Troubleshooting VME=NO
section, p. 26. Ensure that the settings for your DOS
full-screen command prompt in-
cludes the following:
HW_TIMER set to ON
From a full-screen DOS prompt type:
overdriv
e
For Windows 95 users: Press
e
or click OK
When the Main Menu appears, select "Installation Demonstration." If instal-
lation sounds complicated after viewing the installation demo and after
reading through the installation sections of this manual, have a qualified
technician install the Pentium OverDrive processor for you.