Filter
Top Products
NEVER LOOK INTO THE LASER BEAM. Any contact with the eyes by the beam
could cause injury. Do not use the laser when cutting reflective materials.
DO NOT AIM THE LASER BEAM AT ANYONE OR AT REFLECTIVE SURFACES.
CLASS 2M LASER PRODUCT. Any contact with the eyes by the beam could
cause injury. Ensure the laser beam is turned on only when the tool is on a non-
reflective workpiece and as such it is aimed only at the work surface. Metals and
other materials like steel which can be highly reflective should only be cut with-
out the use of the laser.
STORE OUT OF REACH OF CHILDREN. Equipment should be in a high location
or locked up to keep out of reach of children. It is not a toy.
DO NOT TAMPER WITH THE LASER OUTPUT. Changing the performance of the
laser to increase its output is prohibited. Any claim for damages or injuries
resulting from not following these instructions will be refused.
OPERATION ACCESSIBLE FIELDS:
Wavelength 636-660nm
Laser Power for Classification <1mW CW
NEVER OPERATE LASER IF THE UNIT IS DEFECTIVE OR THE COVER OR SEAL
IS DAMAGED.
DO NOT SERVICE LASER. The laser unit must be returned to the factory for any
service or repair. Service or repair must be handled by authorized factory
trained technicians.
Do not open the laser unit except to change batteries.
REMOVE BATTERIES IF THE LEVEL IS TO BE STORED FOR ANY LENGTH OF
TIME. Batteries may leak and damage the laser if it is stored idle for more than
3 months.
Be careful with this tool. Striking or jarring it, especially on the laser housing,
can affect its accuracy.
Other than batteries, there are no user-serviceable parts in the laser device.
When drilling metal, it is a good practice to keep the
workpiece lubricated. This prevents galling and eventual seizing of the drill
bit. Some drill bit models have accessories that automatically lubricate the
metal workpiece. Call Alltrade Customer Service at 1-800-590-3723 to see if
a lubricating accessory is available for this particular drill press.
6. Slowly reverse the feed handles until the drill bit has been cleanly removed from
the workpiece.
7. Turn the drill press ON/OFF switch to the “OFF” and remove the yellow plastic
lock key.
OPERATING THE LASER
LASER SAFETY
Use of controls or procedures, or performance of proce-
dures other then those specified herein may result in hazardous radiation
exposure.
29
W
a
v
e
l
e
n
g
t
h
6
5
0
n
m
A
v
g
.
P
o
w
e
r
<
2
.
0
m
w
C
L
A
S
S
I
I
L
A
S
E
R
P
R
O
D
U
C
T
A
V
O
I
D
E
X
P
O
S
U
R
E
L
a
s
e
r
R
a
d
i
a
t
i
o
n
E
m
i
t
t
e
d
F
r
o
m
T
h
i
s
A
p
e
r
t
u
r
e
L
A
S
E
R
R
A
D
I
A
T
I
O
N
C
A
U
T
I
O
N
LASER RADIATION CAUTION LABEL