Filter
Top Products
– 18 –
OPTIONAL FEATURES
INSTALLATION
K648 or K649 Input Cable Assembly - See Electrical
Installation section for instructions.
K299 50-60 Lb. Wire Reel for Customer Mounting -
The K299 is available for use with the Synergic 7F
Wire Feed Models. The reel for 50 or 60 pound coils is
shipped with the needed mounting shaft, hardware,
and insulation. Shaft mounting hole requirements are
shown below:
K683-1 - Dual Procedure Switch
Dual Procedure
Switch mounts to gun with appropriate bracket,
provided, per the installation instructions included with
the kit. 3-pin switch cord plug connects to 3-pin
remote receptacle on the front panel of the Synergic
7F Wire Feed Unit.
K682-2 Water Connection Kit
- Install to either side
of Wire Feed Unit mounting bracket per instructions
shipped with kit.
K659-1 Gas Guard Regulator - Adjustable flow
regulator with removable adjustor key for CO
2
and
Argon blend gases. Mounts onto Wire Feed Unit inlet
and reduces gas waste and arc start “blow” by reducing
surge caused by excess pressure in supply hose.( See
Shielding Gas Connections for instructions).