Filter
Top Products
C-3
ACCESSORIES
C-3
K1779-1 4' x 4' x 1" Lift Truck Platform.
(See Figure C.3)
Platform for use with the 6000 series stanchion arm.
Install and secure at least 300 lb (136kg) of weight
onto the platform. A welding power source may be
sufficient for this purpose. Verify the weight of the
power source.
K1779-13 Single Electrode Liner Kit
(See Figure C.4)
Includes liner, brackets and hardware for mounting to
a 6000 series arm.
Note: If using a wire feeder with dual drives, two liner
kits are required.
1. Mount the two "A" brackets and one "B" bracket to
the arm. Mount the brackets on either the right or
left side of the arm to match the wire drive location
on the wire feeder. The "A" brackets mount at the
front and middle of the arm. The "B" bracket
mounts towards the rear.
2. Assemble the three pieces of PVC tubing by firmly
inserting the plain ends into the expanded ends.
3. Secure the assembled PVC tubing to the "A" and
"B" brackets using the gear clamps.
4. If a Spindle Mounting Kit is used, mount the "C"
bracket to the spindle Align the bracket as neces-
sary for proper wire alignment.
5. Slide the liner conduit through the PVC tubing.
Secure the liner conduit to the "C" bracket with the
split nylon sleeve and gear clamp.
K1779-9 Universal Wire Feeder Bracket
(See Figure C.5)
Bracket for holding the wire feeder at the end of the
arm. Includes bracket and mounting hardware.
WELDING ARMS
16”
8”
8”
6”
6”
15.5”
7”
48”
48”
3”
Counterweight
location
FIGURE C.3
FIGURE C.4
FIGURE C.5