Filter
Top Products
Use
of
Miter Gauge
Slide the miter gauge into the thick grooves
in the table. Loosen the knob on the gauge
and align to desired angle
(0
to
60').
Bring
stock flush up against fence and feed
gently forward into the blade.
Rip
Fence
The rip fence
is
used for ripping, bevel ripping and rabbeting operations.
CAUTIONS
1.
2.
3.
4.
5.
6.
7.
Remove miter gauge from table.
Secure the adjusting knob tightly on the fence.
Always use
a
push block or stick when there
is
a
danger that your fingers (hand) will
come close to the blade.
Use
a
work support in back whenever cutting long or large workpieces.
Fence should be parallel with the blade
at
all
times.
Spreader should be parallel with the saw blade.
Is
the anti-kickback device in good working operation?
Use
of
Rip
Fence
The rip fence permits repetitive cuts of the
same width or parallel cuts,
as
desired.
Loosen the lock knob on the rip fence and
insert the rail slot for
it
in the table. Then
align the arrow on the rip fence with the
scale
on the table in terms of the desired
cutting width. Now tighten the lock knob
on the rip fence to hold
it
in place.
14