Filter
Top Products
ASSEMBLY PROCEDURE
The tool
is
shipped from the factory with the saw blade and safety guide not in the instal-
led condition. Assemble
as
follows.
CAUTION
Always unplug the tool before assembly.
INSTALLING SAW BLADE
Remove the center cover on the table. Grip
the outer flange with wrench
22;
loosen
the hex nut with wrench
19
and remove
the outer flange.
(See
arrows in photo).
Assemble the inner flange, blade, outer
flange and hex nut onto the arbor, making
sure the teeth of the blade are pointing
down
at
the front of the table.
CAUTIONS:
Keep the flange surface clean of dirt or
other adhering matter;
it
could cause blade
slippage. Be sure that the blade
is
installed
so
that the teeth are aligned in the cutting
(turning) direction.
To secure the blade in place, attach wrench
22
to outer flange, then tighten hex nut
with wrench
19.
Outer
flange
____
k---
Hex
nut
--1
Inner
flange Saw
blade
,
..-
,
ATTENTION:
Be sure to grip hex nut carefully with the wrench. A serious injury can
be sustained, if your grip should slip, the wrench come off the nut, and
your hand strike the sharp blade edges.
6