Filter
Top Products
MAINTENANCE
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection and maintenance.
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down
to the limit mark. Keep the carbon brushes
clean and free to slip in the holders. Both
carbon brushes should be replaced
at
the
same time. Use only Makita carbon brushes.
Lower saw blade
as
far
as
possible with
the elevating knob; free lock lever and
secure
at
point
at
which you can insert
screwdriver through window
of
cutting
/
Limit
mark
Screwdriver
-
Remove the carbon brush and replace with
new one.
17