Filter
Top Products
Installing and adjusting rip fence
Loosen the lever on the rip fence and fit
the rip fence on the ruler guides.
To check to be sure that the rip fence
is
parallel with the blade, secure the rip fence
2
-
3
mm
(5/64"
-
1/8")
from the blade.
Raise
the blade up to maximum elevation.
Mark one of the blade teeth with
a
crayon.
Measure the distance (A) and
(B)
between
the rip fence and blade. Take both measure-
ments using the tooth marked with the
crayon. These
two
measurements should
be identical. If the rip fence
is
not parallel
with the blade, proceed
as
follows:
Insert
a
screwdriver into the hole in the
rear end of the rip fence, then loosen
the screw counterclockwise two or three
turns.
Loosen the
two
bolts on the top of the
rip fence with the wrench.
Adjust the rip fence until
it
becomes
parallel with the blade, then secure
it
by
tightening the bolts.
Tighten the screw in the hole in the rear
end of the rip fence clockwise
two
or
three turns.
Lever
Rip
fence
Ruler
guide
1
I
10