Filter
Top Products
When installing two outside cutters
without any inside cutter, be sure that
the cutter tips do not face each other.
0
X
@
While tightening the hex nut, be careful to maintain the even spacing between the tips
of the inside cutters.
@
When cutting
1/2"
or narrower grooves, use the table insert originally installed on the
table saw. When cutting 9/16" or wider, use optional accessory table insert (Part
No.
343396-9).
Be
sure to install proper table insert.
@
Rotate the dado head one turn by hand to make sure that
it
does not contact anything
before operation.
When dadoing, use featherboards. The
diagram shown illustrates dimensions for
making
a
typical featherbord.
It
should be
made from
a
straight piece of wood that
is
free of knots or craks.
Kerf
should
be
27