Filter
Top Products
MA1 NT ENANCE
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection or maintenance.
Cleaning
Clean out sawdust and chips from time to time.
Carefully clean the balde guard and moving parts inside the table saw.
Lubrication
To
keep the table saw in tip-top running condition, and to assure maximum service life,
oil or grease the moving parts and rotating parts from time to time.
Use machine oil
#I20
to wet the felt on
the slide table and the bars.
Use grease or machine
oil
#I20
for the
moving parts under the table.
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down to
the timit mark. Keep the carbon brushes
clean and free to slip in the holders. Both
carbon brushes should be replaced
at
the
same time. Use only identical carbon
brushes.
Use
a
screwdriver to remove the brush
holder caps. To replace the carbon brush
in the side near the table, lower the blade
as
far
as
possible
by
turning the knob.
Loosen the lock lever,
tilt
the blade and
secure
it
at
45
degrees. Then loosen the
brush holder cap while viewing
it
through
the opening in the base.
Remove the worn carbon brushes, insert
the new ones and secure the brush holder
caps.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
24