Filter
Top Products
Tighen the lever on the rip fence. If the rip
fence
is
not
secure enough,
leave
the
lever
in the tightened position and tighen the
screw in the hole in the rear end
of
the rip
fence clockwise. However, do not tighten
the screw excessively, or the lever will be-
come loose.
I
CAUTION
:
Be sure to adjust the rip fence parallel with the blade, or
a
dangerous kickback condition
may occur.
Move the rip fence
a
bit away from the
blade and secure
it.
Use
a
ruler to measure
the distance
(A)
between the rip fence and
blade. Make sure that the pointer on the
ruler guide points to the correct graduation.
If
the pointer does not point to the correct
graduation, loosen the screw on the pointer.
Then align the pointer with the correct
graduation and tighten the screw.
Blade
11