Filter
Top Products
P 3/ 13
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. LED job light section
DISASSEMBLING
M4x8 Pan head screw (2pcs.) Light cover
1) Remove Light cover by unscrewing two M4x8 Pan head screws. (Fig. 2)
2) Remove LED circuit and its Lead wires from Light holder, and disconnect Connector of LED circuit with that of
Motor control unit. Switch lever and Compression spring 2 can be removed in this step. (Fig. 3)
Connector of
LED circuit
Connector of
Motor control
unit
LED circuit
Lead wire
Light holder
Compression spring 2 Switch lever
Fig. 2 Fig. 3
RibSwitch unitLead wire holders
Fig. 5Fig. 4
Light cover protrusion Notch of Angle
head complete
Note: Put Connectors and the slack portion of Lead wires in
this space. Do not put them on Switch unit and the rib.
[3] -2. Spindle A complete section
DISASSEMBLING
Fig. 9Fig. 8
24mm
Fig. 6 Fig. 7
Bearing retainer 14-23
Angle head complete
Bearing retainer 14-23
Spindle A complete
Bearing retainer 14-23
Spindle A complete
Spindle A
complete
Flat washer 6
Wrench
1) Connect Connector of LED circuit with that of Motor control unit. and put LED circuit in place on Light holder.
Then fix lead wires with Lead holders as illustrated in Fig. 4.
2) Fitting the protruding portion of Light cover in the notch of Angle head complete, assemble Light cover to
Angle head complete by screwing two M4x8 Pan head screws. (Fig. 5)
Note: Be careful not to pinch the slack portion of Lead wires between Light cover and Angle head complete.
ASSEMBLING
1) Remove Bearing retainer 14-23 from Angle head complete by turning clockwise with wrench of 24mm flats width.(Fig. 6)
Spindle A complete section can now be removed by pulling by hand. (Fig. 7)
2) Remove Flat washer 6 from Spindle A complete. (Flat washer 6 may remain in Angle head complete.)
Remove Spindle A complete from Bearing retainer 14-23 by pushing down Bearing retainer 14-23 in the direction of
the arrow by hand. (Fig. 8)
Note: If cannot be removed by hand, disassemble by pressing down Spindle A complete using arbor press. (Fig. 9)
Spindle A complete section
Bearing
retainer 14-23