Filter
Top Products
P 4/ 13
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Spindle A complete section (cont.)
1) Apply Makita grease N.No.2 to O ring 14. (Fig. 1)
Assemble O ring 14, Flat washer 14 then Spindle complete to Bearing retainer 14-23 as illustrated in Fig. 10.
Note: If you cannot assemble Spindle complete to Bearing retainer 14-23 by hand, do it using arbor press as illustrated in
Fig. 11.
2) Apply about 2g of Makita grease N.No.2 to the Gear room of Angle head complete. (Fig. 1)
Note: Be careful not to put Makita grease N.No.2 on the threaded portion of Angle head complete.
3) Apply Loctite 603 to the threaded portion of Bearing retainer 14-23. (Fig. 1)
Then assemble Flat washer 6 to Spindle complete. (Refer to Fig. 8.)
Assembling of Spindle complete section has been completed.
4) Clamp the flats of Angle head complete securely in a vise to which 1 set of 1R041 is attached, then assemble Spindle A
complete section to Angle head complete by turning Bearing retainer 14-23 counterclockwise using 1R219, 1R220, 1R222
and 134861-3 as illustrated in Fig. 11.
Caution: When clamping Angle head complete, be very careful not to deform it by overtightening.
ASSEMBLING
Fig. 11Fig. 10
Recommended tightening torque:
30 to 50N.m
1R2191R220
1R222
134861-3
1R041
Bearing retainer 14-23
O ring 14
Flat washer 14
Spindle A complete