Filter
Top Products
[3] DISASSEMBLY/ASSEMBLY
[3] -7. Impact Bolt Section (cont.)
DISASSEMBLING
ASSEMBLING
Fig. 29
Note: Use an extra Piston cylinder as a jig. Never use Piston cylinder that is to be
assembled to the machine.
2) Push Ring spring 28 with Piston cylinder until it fits to the inner groove of Tool holder complete. (Fig. 29)
1) Disassemble Tool holder section as illustrated in Fig. 3.
2) Disassemble Change lever as illustrated in Figs. 4 and 5.
3) Separate Gear housing complete from Motor housing complete. And then, remove Armature from Gear housing complete.
(Refer to Figs. 8 to 10.)
4) Remove Stop ring E-4, Flat washer 5 and Compression spring 6 from pin of Inner housing complete. (Fig. 30)
5) Remove two M4x12 Hex socket bolts that fasten Bearing retainer to Inner housing complete. (Fig. 31)
[3] -8. Swash Bearing Section
Flat washer 5
Stop ring E-4
Compression spring 6
Change plate
Pin of Inner housing complete M4x12 Hex socket
head bolt (2 pcs.)
Fig. 30 Fig. 31
Repair
P 8 / 13
Piston cylinder
as a repairing jig
Piston cylinder
as a repairing jig
Tool holder
complete
Ring spring 28
Inner groove of
Tool holder complete
Ring spring 28
O ring case