Filter
Top Products
[3] DISASSEMBLY/ASSEMBLY
[3]-3. Change lever
While pushing Lock button into Change lever,
turn Change lever a little over Drill mode position
to lock it in place.
While pushing Lock button into Change lever, fit Change lever
completely to Gear housing complete.
Note: Be sure to check Change lever works properly
after assembling.
Insert slotted screwdriver between Change lever and
Gear housing complete, then lever up Change lever.
Drill mode
Lock button
Change lever
DISASSEMBLING
Fig. 19
Fig. 20
(thick pin of
Change lever)
Hammer mode
thin pin of
Change lever
ASSEMBLING
Fig. 21
Change plate can be seen through Change lever insertion hole of Gear housing complete.
While hooking the thin pin of Change lever to Change plate from Hammer mode side,
turn Change lever to Drill mode side.
Note: Change lever is incompletely fit to Gear housing complete in the above step.
slotted screwdriver
Change lever
Lock button
Drill mode
Change plate
Viewed from the upper side
Repair
P 9/22
Drill mode