Filter
Top Products
OM-203 034 Page 16
4-5. Selecting A Location
loc_2 3/96 - 800 611 / 802 260
1 Lifting Forks
Use lifting forks to move unit.
Extend forks beyond opposite side
of unit.
2 Lifting Handles
Use handles to lift unit.
3 Hand Cart
Use cart or similar device to move
unit.
4 Rating Label - Typical
Use rating label to determine input
power needs.
5 Line Disconnect Device
Locate unit near correct input
power supply.
! Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
Movement
3
Location
5
18 in
(460 mm)
18 in
(460 mm)
Tipping
1
OR
2
! Do not move or operate
unit where it could tip.
4
4-6. Connecting To Weld Terminals
! Turn off power before con-
necting to weld output ter-
minals.
1 Positive (+) Weld Output
Terminal
2 Negative (−) Weld Output
Terminal
Connect positive weld cable to
Positive (+) weld terminal and
negative (−) cable to Negative
weld terminal.
Tools Needed:
Ref. 802 260
1
2