Miller Electric Bobcat 250 Welding System User Manual


 
. A complete Parts List is available at www.MillerWelds.com
OM-4419 Page 18
5-2. Engine Prestart Checks (Robin-Powered Units)
803 755-C / 217 015-A
Full
Full
Gasoline
Check all fluids daily. Engine must
be cold and on a level surface. Unit
is shipped with 10W30 engine oil.
. Follow run-in procedure in en-
gine manual.
NOTICE This unit has a low oil
pressure shutdown switch. Howev-
er, some conditions may cause en-
gine damage before the engine
shuts down. Check oil level often
and do not use the oil pressure
shutdown system to monitor oil
level.
Open top service door.
Fuel
To help prime the fuel system at ini-
tial start-up, fill tank with fresh fuel
(see maintenance label for specifi-
cations). Always leave filler neck
empty to allow room for expansion.
Check fuel level on a cold engine
before use each day.
Oil
. Do not exceed the ”Full” mark
on the oil level dipstick. The
fuel pump may operate errati-
cally if crankcase is overfilled.
After fueling, check oil with unit on
level surface. If oil is not up to full
mark on dipstick, add oil (see main-
tenance label).
. To improve cold weather
starting:
Keep battery in good condition.
Store battery in warm area.
Use correct grade oil for cold
weather.
Close top service door.
Oil Check
Oil Fill
0
1/2
1
H
0000