Miller Electric PipePro 304 Welding System User Manual


 
OM-492 Page 17
5-2. Engine Prestart Checks
802 330-G
1/2 in
(13 mm)
Full
Diesel
Check all fluids daily. Engine must be cold
and on a level surface. Unit is shipped with
10W30 engine oil.
Engine stops if oil pressure is too low or en-
gine temperature is too high.
. This unit has a low oil pressure shut-
down switch. However, some condi-
tions may cause engine damage before
the engine shuts down. Check oil level
often and do not use the oil pressure
shutdown system to monitor oil level.
Follow run-in procedure in engine manual. If
unburned fuel and oil collect in exhaust pipe
during run-in, see Section 10.
Fuel
NOTICE Do not use gasoline. Gasoline
will damage engine.
Add fresh diesel fuel before starting engine
the first time (see maintenance label for
specifications). Fill fuel tank up to 1/2 in. (13
mm) from top to allow room for expansion.
Do not run out of fuel or air enters fuel sys-
tem and causes starting problems. See en-
gine manual to bleed air from fuel system.
Oil
After fueling, check oil with unit on level sur-
face. If oil is not up to full mark on dipstick,
add oil (see maintenance label).
NOTICE Engine may use oil and wets-
tacking may occur during run-in period.
Check oil several times daily during run-in.
Coolant
Check coolant level in recovery tank before
starting unit the first time. Add coolant if
coolant is below bottom of radiator filler neck
(see Section 5-3 for radiator filling instruc-
tions.
Check coolant in recovery tank daily. If cool-
ant is below Full level, add coolant until cool-
ant level in tank is between Full and Low lev-
els. If recovery tank coolant level was low,
also check coolant level in radiator (see
Section 5-3).
Engine coolant is a mixture of water and
ethylene glycol base antifreeze. A solution
of 50% antifreeze and 50% water must be
used in this engine. Do not use 100% anti-
freeze or severe damage will occur.
Keep radiator and air intake clean and free
of dirt.
NOTICE Incorrect engine temperature
can damage engine. Do not run engine with-
out a properly working thermostat and ra-
diator cap.
. To improve cold weather starting:
Keep battery in good condition. Store
battery in warm area.
Use fuel formulated for cold weather
(diesel fuel can gel in cold weather).
Contact local fuel supplier for fuel
information.
Use correct grade oil for cold weather
operation (see Section 6-6).
Full
Full
Check radiator coolant
level when fluid is low
in recovery tank.
Full
Capacity
w/Overflow Tank
6.4 qt (6 L)