Filter
Top Products
. A complete Parts List is available at www.MillerWelds.com
OM-201 872 Page 37
40 Amp Machine Torch Extended Consumables
The following cut charts are based on a distance of 3/16 in (4.8 mm) between torch tip and workpiece for all cuts.
212 734212 724212 729212 733212 736
Swirl RingElectrodeTipRetaining CapDeflector
ICE-100TM Torch
Mild Steel
Arc Current
Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current
Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
126 0 14 ga 1.9 320 8,128 214 5,435
40
134 0.75 3/16 4.8 95 2,413 63 1,600
40
138 1 1/4 6.4 73 1,854 49 1,245
Stainless
Arc Current
Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current
Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
123 0 18 ga 1.3 515 13,081 328 8,331
40
130 0.25 14 ga 1.9 222 5,638 145 3,683
40
138 1 1/4 6.4 50 1,270 35 889
Aluminum
Arc Current
Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current
Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
40
148 0.5 1/8 3.2 214 5,435 135 3,429
40
150 1 1/4 6.4 81 2,057 52 1,320
Without concern for cut appearance, the fastest speed for cutting material is the maximum cut speed. For better cut angle, less dross, and cut surface
appearance, use the optimum cut speed. The values in the cut charts are basic starting points and each application may require some adjustment to
achieve the best cut characteristics.