Filter
Top Products
OM-1599 Page 12
4-4. Installing And Aligning Wire Guide And Drive Rolls
802 706-A / Ref. 132 808-F / Ref. 162 079-A / Ref. 180 967
Installing Wire Guide And Drive
Rolls:
1 Drive Roll Nut
2 Drive Roll Carrier
Turn nut one click until lobes of nut
line up with lobes of drive roll carrier.
3 Drive Roll
Slide drive roll onto drive roll carrier.
Turn nut one click.
Repeat procedure for top drive roll.
4 Inlet Wire Guide Screw
5 Inlet Wire Guide
Loosen securing screw. Install inlet
guide so inlet guide screw is
centered in groove in guide, or so tip
is as close to drive rolls as possible
without touching. Tighten screw.
Aligning Wire Guide And Drive
Rolls:
View is from top of drive rolls look-
ing down with pressure assembly
open.
6 Drive Roll Securing Nut
7 Drive Roll
8 Wire Guide
9 Welding Wire
10 Drive Gear
Turn screw in or out until drive roll
groove lines up with wire guide.
Close pressure roll assembly.
Only bottom drive roll alignment is
adjustable. Turn adjustment screw
in or out until groove in drive roll
lines up with wire guide as shown.
Cleaning Drive Rolls:
Remove drive rolls, and clean
grooves using a wire brush.
Tools Needed:
3/16 in
Aligning Wire Guide And Drive Rolls
Correct Incorrect
8
7
6
10
3/8 in
1
2
3
4
5
Installing Wire Guide
And Drive Rolls
9