Filter
Top Products
OM-1599 Page 17
SECTION 6 − MAINTENANCE & TROUBLESHOOTING
6-1. Routine Maintenance
Y Disconnect power
before maintaining.
. Maintain more often
during severe conditions.
3 Months
Replace
Damaged Or
Unreadable
Labels
Replace Damaged
Gas Hose
Repair Or Replace
Cracked Cables
And Cords
6 Months
Clean
Drive
Rolls
Blow Out Or
Vacuum Inside
6-2. Overload Protection And Thermostat Protection
Ref. 802 706-A
Y Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
1 Circuit Breaker CB1
CB1 protects wire feeder from over-
load. Correct problem and reset
CB1.
Close and latch door.
Thermostat Protection
Unit has internal thermostat protec-
tion and will not feed wire if over-
heating occurs (see Section 6-3).
CB1
1
Internal Side View