Miller Electric 301 G, DC Welding System User Manual


 
OM-4407 Page 16
5-2. Engine Prestart Checks (Robin EH64-Powered Units)
803 098 / 800 392-J
Full
Full
Gasoline
Check all fluids daily. Engine must be
cold and on a level surface. Unit is
shipped with 10W30 engine oil.
. Follow run-in procedure in en-
gine manual.
. This unit has a low oil pressure
shutdown switch. However,
some conditions may cause en-
gine damage before the engine
shuts down. Check oil level often
and do not use the oil pressure
shutdown system to monitor oil
level.
Fuel
Add fresh fuel before starting engine
the first time (see maintenance label
for specifications). Always leave filler
neck empty to allow room for expan-
sion. Check fuel level on a cold en-
gine before use each day.
Oil
After fueling, check oil with unit on
level surface. If oil is not up to full
mark on dipstick, add oil (see mainte-
nance label).
. To improve cold weather
starting:
Keep battery in good condition.
Store battery in warm area.
Use correct grade oil for cold
weather.
Oil Check Oil Fill