Filter
Top Products
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 12
MQ SP-3035 CONCRETE SAW
General Safety Warnings
WARNING
ALWAYS read, understand, and follow procedures in the Operator’s
Manual before attempting to operate the equipment.
Be sure the operator is familiar with proper safety precautions and
operating techniques before using the saw.
Make sure the operating area is clear before starting the engine.
Maintain this equipment in a safe operating condition at all times
Keep the saw clean. It will work better and last longer
Use proper blades and follow the blade manufacturer’s
recommendations. Match blade rpm (Spindle rpm) to recommended
blade surface feet per minute (SFPM).
Tighten the 5/8” blade-mounting bolt to 100-125 foot-lbs. torque.
Turn engine OFF prior to fueling the saw!
Start engine with the joystick in NEUTRAL to prevent unexpected saw
movement.
Do not leave saw unattended while engine is running.
Do not start engine on a sloping surface to prevent unexpected loss of
control.
Do not park or leave saw unattended on a slope - the saw can roll when
the engine is OFF. Block the unit when leaving.
If the saw must be parked on a slope, turn it across the angle of the
slope, to prevent accidental downhill movement.
Prior Always store equipment properly when not being used. Equipment
should be stored in a clean, dry location out of the reach of children.
When storing the saw in freezing weather, blow out water lines to
prevent damage to components in the water delivery system.
Prior to service, level the frame surface.
Do not over tighten the Spindle drive belt
Turn on water flow prior to starting the engine, to prevent damage to the
impeller of a belt-driven water pump.
Don’t pollute! Waste oils and other chemicals must be disposed of in a
manner consistent with local and state environmental protection
regulations.