Filter
Top Products
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 41
MQ SP-3035 CONCRETE SAW
Belts and Pulleys
Belt Qty Part Number
Spindle Drive Belt (POWERBAND) 1 520006
Transaxle Drive Belt 1 521005
Engine to Jack shaft Drive Belt 1 521005
Fig. 27 — Belt Locations
V-Belt Tension
The ideal V-Belt tension is the lowest tension at which the belt will not slip under peak load
conditions. Check V-Belt tension frequently during the first 24-48 hours of run-in operation.
CAUTION
Over-tensioning shortens belt and bearing life.
Keep belts clean of foreign material that may cause slippage.
Make V-Belt inspection a periodic procedure.
Never dress belts, as this causes premature failure.
TransAxle Drive Belt
Spindle
(Blade Shaft)
Drive Belt
Engine to
Jack Shaft
Drive Belt