Filter
Top Products
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 56
MQ SP-3035 CONCRETE SAW
Draining & Filling the Hydraulic System
To drain the Transaxle
1. Remove the drain plug from the bottom of the Spindle housing and the bottom of the
Transaxle.
Fig. 43 — Transaxle Drain Plug
NOTE
Collect and dispose of the used oil and oil filter in an environmentally
friendly manner. Do not drain onto the ground or pour used oil down
drains.
2. Remove the old oil filter. See Fig. 43, above.
3. Once drained, reinstall the drain plugs.
4. Pre-fill and install a new oil filter.
5. Refill the Transaxle with hydraulic oil as outlined on page 58
CAUTION
Pre-fill the oil filter with oil prior to installing to prevent hydraulic
pump damage.
To drain the Spindle
NOTE
The fully enclosed Spindle eliminates most maintenance. However, if
the Spindle ever needs service or repair, contact Multiquip, at the
number listed in the inside of the front cover for details.
Drain Plug