Multiquip SP303530 Saw User Manual


 
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 20
MQ SP-3035 CONCRETE SAW
Installing the Blade, Blade Guard & Blade Flange
Remain Clear of all parts of saw while installing blade to
prevent crush injury or death.
Verify the engine start switch is OFF before installing
blade.
WARNING
Tighten the 5/8” blade-mounting bolt to 100-125 foot-
pounds torque.
The blade can be mounted on either side of the saw to accommodate different cutting jobs.
1. Raise the saw so that the blade will clear the ground when installed.
2. Verify that blade flanges are clean and undamaged.
3. Insert the bushing and mounting bolt through the outer flange and blade.
4. Align flange pin through the blade into the inner flange.
5. Tighten the 5/8” mounting bolt to 100-125 foot-pounds of torque.

NOTE
The blade mounting bolt on the right side of the saw (as viewed from the
operator’s position) has a left hand-thread, while the blade-mounting bolt on
the left side of the saw has a right-hand thread.
Fig. 6 — Blade Components
Blade Guard
Mounting Clip
Inner Flange
Tapered
Spindle Shaft
Outer Flange
with Pin
Flange
Bushing
Mounting
Bolt