Filter
Top Products
Ref. No. 1C Procedure 1A →
→→
→ 1B →
→→
→ 1C Removal of Motor Mounting Base.
1. To remove the ring gear, unhook right and left
side of the projections using a flat screwdriver.
2. After removing the ring gear, the internal parts
can be remove one after another.
3. Loosen 3 screws tightened with the motor
mounting base.
Ref. No. 1D Procedure 1A →
→→
→ 1B →
→→
→ 1D Removal of Gear Box Assembly.
1. Hold the driving carrier as illustrated.
Compress the assembly and remove the pin.
2. Take out the driving shaft assembly and the
gear case assembly from the shaft of the driving
carrier.
NOTE :
Make sure not to lose the pin and the
connect piece.
4
EY6535-U1