Filter
Top Products
Ref.No.2C Procedure 2A→
→→
→2B→
→→
→2C Assembly of Gear Box Assembly.
1. Fit the driving carrier into the hole of the gear
case assembly and the driving shaft assembly.
2. Confirm the connect piece is inside of the
driving shaft block.
3. Insert the pin into the shaft of the driving
carrier holding the bottom of the gear box
assembly (driving carrier) by hand.
4. Align the wider protrusion of motor mounting
base with the wider protrusion of gear case.
Ref.No.2D Procedure 2A→
→→
→2B→
→→
→2C→
→→
→2D Assembly of Motor and Switch.
1. Fit terminal of lead wire (black) parallel to the
heat sink.
Caution:
Be careful that the heat sink and the terminal
do not touch, otherwise these are
shortcuircuit.
8
EY6535-U1