Filter
Top Products
Ref.No.2E Procedure 2A→
→→
→2B→
→→
→2C→
→→
→2D→
→→
→2E Assembly of Housing.
1. Confirm proper position of the click springs
and the position in each housing A and B.
2. Check that the widest protrusion (6mm) of
adjusting screw is in the middle and the mode
change handle is set to the IMPACT position.
3. Set anvil and slider, has its own correct
direction. Confirm the direction when assembling.
4. Set the clutch handle with position 1 on top.
5. When setting fixation cover, align
mark on
top.
6. Tighten 4 screws.
9
EY6535-U1