Patton electronic SIP 3CX Work Light User Manual


 
Compliance 32
SmartNode Branch eXchange User Manual A • Compliance information
Compliance
EMC Compliance
FCC Part 15, Class B
EN55022, Class B
EN55024
Low-Voltage Directive (Safety):
IEC/EN60950-1 2nd Edition
CE Declaration of Conformity
Patton Electronics, Inc declares that this device is in compliance with the essential requirements and other rele-
vant provisions of Directive 2004/108/EC relating to electromagnetic compatibility, Directive 2006/95/EC
relating to electrical equipment designed for use within certain voltage limits and Directive 2011/65/EU relat-
ing to RoHS compliance. The Declaration of Conformity may be obtained from Patton Electronics, Inc at
www.patton.com/certifications.
The safety advice in the documentation accompanying this device shall be obeyed. The conformity to the
above directive is indicated by CE mark on the device.
Authorized European Representative
D R M Green, European Compliance Services Limited.
Greyfriars Court, Paradise Square, Oxford, OX1 1BE, UK
FCC Part 15
This device generates and uses radio frequency energy, and if not installed and used properly-that is, in strict
accordance with the manufacturer’s instructions-may cause interference to radio and television reception. The
device has been tested and found to comply with the limits for a Class B computing device in accordance with
specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection from
such interference in a commercial installation. However, there is no guarantee that interference will not occur
in a particular installation. If the device does cause interference to radio or television reception, which can be
determined by disconnecting the unit, the user is encouraged to try to correct the interference by one or more
of the following measures: moving the computing equipment away from the receiver, re-orienting the receiving
antenna and/or plugging the receiving equipment into a different AC outlet (such that the computing equip-
ment and receiver are on different branches).