Filter
Top Products
11
5. Insert threaded end of support rod / splitter bracket
(G) Fig. 12, through slot in rear of saw and into hole in
rear trunnion (H). Fasten support rod / splitter bracket (G)
to trunnion with a M12.1 washer and M12x1.75 hex jam
nut (J) Fig. 13. NOTE: Thread nut (J) Fig. 13, onto threads
of support rod (G) as much as possible by hand.
Fig. 12 Fig. 13
6. Using a wrench to hold the M12x1.75 hex jam nut (J)
Fig. 13, tighten rod (G) Fig. 14, by inserting a small
screwdriver (K) or similar device through the hole in the
end of the rod.
Fig. 14
Fig. 16 Fig. 17
8. Insert the front end of splitter (P) Fig. 16, inside the
splitter mounting bracket behind splitter fastener plate
and screw (C). Push splitter down as far as possible,
making certain the bottom edge of splitter (P) is parallel
with the table surface. Tighten screw (C) Fig. 16. Fasten
splitter and blade guard assembly (P) Fig. 17, to bracket
(M) using an M8x1.25x25mm hex head screw (V) and
M8.1 flat washer (O).
G
H
J
G
K
P
C
P
M
V
O
Fig. 15
7. Loosen screws (T) and (U) Fig. 15, and remove
screw (V) and washer (O).
V
T
U
M
O