Filter
Top Products
13
12. Holding the clear blade guard, lower the saw blade
and assemble the table insert (E) Fig. 24, into the open-
ing on the saw table. Tighten screw (F) to fasten the table
insert to the saw.
Fig. 24
13. Place a straight edge (B) across the table at both
ends of the table insert as shown in Fig. 25.
THE TABLE INSERT (A) SHOULD
ALWAYS BE LEVEL WITH THE TABLE.
If an adjustment is necessary, remove the table insert
screw (F) Fig 25, and turn the adjusting screws, on the
bottom of the insert, as needed, with the 3mm hex
wrench supplied.
Replace the table insert and recheck the table insert and
adjust insert until it is level with the table.
Fig. 25
MOTOR COVER
1. Align the two hinge pins (A) Fig. 26 on the motor
cover with the two hinge catches (B) on the right side of
the cabinet.
2. Insert the hinge pins (A) Fig. 26 on the motor cover
into the two hinge catches (B).
3. Turn handle (C) Fig. 27 clockwise, and close motor
cover (D).
4. Turn handle (C) Fig. 27 counterclockwise to lock
motor cover with cabinet.
Fig. 27
Fig. 26
F
A
A
B
B
C
D
B
A
F