Filter
Top Products
ADJUSTING DEPTH OF CUT
DISCONNECT TOOL FROM POWER SOURCE.
1. Loosen base locking screw (Fig. 3) approximately one-quarter turn.
2. Turn depth adjusting wheel (Fig. 3) clockwise, looking at top of wheel,
to raise cutter reducing depth of cut or counterclockwise to lower cutter for
increasing depth of cut.
3. Tighten base locking screw securely and make a test cut in scrap
material and check depth of cut.
4. Repeat steps 1 through 3 until desired depth of cut is achieved.
ADJUSTING SUB-BASE ALIGNMENT
Applications using a templet guide require the bit to be centered within the
guide. This, in turn, requires the center hole in the sub-base to be in line
with the collet of the motor unit. Your model has an adjustable sub-base
which has been aligned at the factory. If the sub-base has been removed
and/or readjustment is required, proceed as follows:
DISCONNECT TOOL FROM POWER SOURCE.
1. Install 42054 Templet Guide (available as an accessory) to the subbase and
tighten securely.
2. Loosen sub-base mounting screws just enough to allow sub-base to move on
base.
3. Install a straight
1
/
4" diameter bit in collet of motor unit and tighten securely.
4. Assemble motor unit to base, align hole in templet guide with
1
/
4" diameter bit
and adjust depth of cut so that bit extends through templet guide. Tighten motor unit
in base.
5. Tighten sub-base mounting screws securely.
73100 EDGE GUIDE KIT
The Model 73100 Edge Guide Kit is available (as an accessory), for use with
the Model 310 trimmer. The 73100 is designed for use with non-piloted bits,
on curved or straight applications. Non-piloted bits can produce a 90°
straight cut, a 10° bevel cut, or a 22° bevel cut. The kit (Fig. 4) contains:
A – Base and roller guide - for flush or bevel trimming
B – Edge guide – for flush trimming
C – Edge guide – for bevel trimming
D – Straight edge guide – for straight trimming
E – Guide setting gauge
F – Mounting screws
G – Wrench
DISCONNECT TOOL FROM POWER SOURCE.
Fig. 3
LOCKING
SCREW
SPRING
WASHER
DEPTH ADJUSTING
WHEEL
12