Filter
Top Products
17
3. DISCONNECT TOOL FROM POWER SOURCE.
4. Firmly grasp motor housing being
sure switch is in the “OFF” position.
5. Verify bit is clear of foreign objects
and cord will not “hang up” on any
obstructions.
6. Be sure workpiece is firmly held in
place. Use clamps where necessary to
secure workpiece.
7. Plug in power supply cord. Be alert
to resist starting torque of motor. Turn
motor “ON”.
8. Allow motor to reach “full speed”.
Place base of trimmer on surface to be trimmed and feed into work until bit
pilot contacts base material. When guiding on a previously laminated
surface, always wax or lubricate the area that trimmer will guide against.
NOTE: While operating trimmer with tilt base at any tilt setting other
than “0” degrees, the long side of the base must be kept
perpendicular to the piloting surface to prevent possible work
spoilage.
9. Feed from left to right with a smooth steady motion (See Fig. 13).
10. At completion of trimming operation, turn switch “OFF”. Allow motor to
come to a complete stop before laying trimmer down.
Fig. 12
SUB-BASE
INVERTED
3
/
16"
➤
➤
Fig. 13