Filter
Top Products
13
ASSEMBLING AND ADJUSTING BASE AND ROLLER GUIDE
1.
Remove power unit from base unit (see “TO INSTALL BIT”), and install the bit.
2.
The base and roller guide (A) Fig. 4, is assembled at the factory. To
assemble, remove a sub-base mounting screw (A) Fig. 5 and insert alignment pin
in guide base into hole (C) in bottom of trimmer sub-base. Fasten with two
mounting screws (F) Fig. 4, as shown in Fig. 5A. Do not tighten at this time.
3. Install proper bit as outlined under “TO INSTALL BIT.” Then, install motor to
base and adjust depth of cut (see “ADJUSTING DEPTH OF CUT”).
4. Align roller guide with bit by loosening locking screw (Fig. 5A) and turning
adjusting screw, with hex wrench provided, until guide is in desired location.
NOTE: Guide mounting holes are oversized allowing guide to be
rotated on alignment pin to align guide roller with bit.
5. For making flush cuts align roller guide with straight portion of bit. For
bevel cuts, adjust cutting depth so that only the bevel portion of bit projects
through trimmer base and adjust roller guide to produce desired amount of
bevel.
6. Tighten all screws and make a trial cut on scrap material to check
alignment. Readjust if necessary.
FLUSH TRIMMING
1. DISCONNECT TOOL FROM POWER SOURCE.
2. Attach base and guide to trimmer as outlined under ASSEMBLING AND
ADJUSTING BASE AND ROLLER.
3. Remove roller guide and replace with flush trimming guide (B) Fig. 4.
This guide may be identified by the molded on letter “F”. The stud on the end
of this guide must face toward the trimmer base.
4. Install guide setting gauge (E) Fig. 4, into trimmer collet (see TO INSTALL
BIT). Install trimmer motor to base. Adjust guide so that hole in end of gauge
may be positioned over the guide stud.
Fig. 4
ABCD EFG
ADJUSTING
SCREW
LOCKING SCREW
MOUNTING
SCREW
Fig. 5A
Fig. 5
A
C