Filter
Top Products
6
Introduction
This manual is provided by WMH Tool Group covering the safe operation and maintenance procedures
for a Powermatic Model 2800 Drill Press. This manual contains instructions on installation, safety
precautions, general operating procedures, maintenance instructions and parts breakdown. This machine
has been designed and constructed to provide years of trouble free operation if used in accordance with
instructions set forth in this manual. If there are any questions or comments, please contact either your
local supplier or WMH Tool Group. WMH Tool Group can also be reached at our web site:
www.wmhtoolgroup.com.
Specifications
Model Number................................................................................................................................... 2800
Stock Number...............................................................................................................................1792800
Swing (in.)............................................................................................................................................. 18
Maximum Drilling Capacity (in.)............................................................................................................. 5/8
Chuck Size (in.).................................................................................................................................... 5/8
Spindle Travel (in.) ............................................................................................................................ 4-3/8
Chuck Distance to Table (in.)................................................................................................................. 30
Chuck Distance to Base (in.).................................................................................................................. 46
Table Size (LxW)(in.)......................................................................................................................16 x 14
Table Size Fully Extended (LxW)(in.) ..............................................................................................16 x 26
Spindle Taper............................................................................................................................MT2 x JT3
Column Diameter (in.)........................................................................................................................ 3-1/8
Range of Spindle Speed (RPM)...............................................................................................400 to 3000
Base Size (in.)....................................................................................................................11-7/8 x 19-5/8
Motor............................................................................................TEFC, 1HP, 115/230V (pre-wired 115V)
Overall Dimension (HxWxD)(in.)................................................................................. 68-1/2 x 20 x 31-1/2
Approximate Net Weight (lbs.) ............................................................................................................. 209
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, WMH Tool Group reserves the right to change specifications at any time and
without prior notice, without incurring obligations.