Filter
Top Products
30
11. Check Software Version
To check the released version of the M15S Controller program:
Step 1: Press
Display
In the real value window, you will see the released version.
Step 2: Press
to confirm or press
to clear.
12. Load Datum Values
The real value refers to the distance between the machine table and the cutterhead.
Thus, the cutterhead defines the zero point of the machine. It is, however, difficult or
impossible to move the planer table to this point. Therefore, the zero point should be
identified by either placing a gauge between table and cutterhead knife insert, or by
planing a test board then measuring the board thickness with calipers. Program this real
value into the Controller as follows.
Preset the real value:
Step 1:
Step 2: Enter the value.
Step 3: Press