Filter
Top Products
19
ASSEMBLY
Fig. 20
MOUNTING THE SWITCH BOX
See Figure 20.
n Locate the following hardware:
2 pan head screws (M5 x 0.8-12)
2 lock washers (M5)
n Mount switch assembly to frame as shown using pan
head screws. Thread screws into band saw chassis using
a Phillips screwdriver.
MOUNTING THE DUST CHUTE
See Figure 21.
n Locate the following items:
2 pan head screws (M6 x 1)
1 dust chute
n Open lower blade guard cover and install dust chute
pointing down. Thread pan head screws from the inside
of the lower blade guard cover into the dust chute.
n Close lower blade guard cover.
MOUNTING THE TABLE TRUNNION SUPPORT
TO BAND SAW
See Figure 22.
n Locate the following items:
2 hex head bolts (M8 x 35)
2 lock washers (M8)
1 table stop bolt (M8 x 80)
1 nut (M8)
1 trunnion support
n Place trunnion support on saw body and align using pins
mounted as shown.
n Thread hex head bolts into band saw using lock washers.
Tighten.
n Thread hex nut half way onto table stop bolt. Thread table
stop bolt into trunnion support.
Fig. 21
Fig. 22
P
U
S
H
P
U
L
L
O
FF
ON
I
P
L
U
L
P
L
U
L
PAN HEAD
SCREWS
HEX HEAD
BOLTS
LOCK
WASHERS
SWITCH
ASSEMBLY
PAN HEAD
SCREWS
DUST CHUTE
LOWER BLADE
GUARD COVER
LOCK
WASHERS
TABLE STOP
BOLT
HEX NUT
TRUNNION
SUPPORT
PINS
SAW BODY
SAW
BLADE