Filter
Top Products
27
P
L
U
L
10
°
0
°
15
°
30
°
45
°
OPERATION
Fig. 38
TILTING THE TABLE
See Figure 38.
n Loosen the lock knob slightly.
n Turn the angle adjustment knob, tilt the saw table toward
the front of the saw housing until it reaches the desired
angle.
n Using the scale indicator, check angle markings.
n Retighten the lock knob to hold saw table securely in
place.
CIRCLE CUTTING
See Figure 39.
n Adjust the upper guides to vertically just clear the
workpiece.
n Use both hands while feeding the work into the blade.
Hold the workpiece firmly against the table. Use gentle
pressure, and do not force the work, but allow the blade
to cut.
n The smallest diameter that can be cut out is determined
by the width of the blade. For example, a 1/4 in. (6 mm)
wide blade will cut a minimum diameter of approximately
1-1/2 in. (38 mm).
Fig. 39
TABLE STOP
BOLT
JAM NUT
LOCK KNOBS
SAW TABLE
SCALE
INDICATOR
SCALE
CIRCLE CUTTING
CIRCLE DIA.
1/2"D
1/8"
1"D
1/16"
1-1/2"D
1/4"
2"D
3/8"
4"D
1/2"
7"D
3/4"
BLADE SIZE