Filter
Top Products
30
MAINTENANCE
WARNING:
When servicing, use only identical replacement
parts. Use of any other part may create a hazard
or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with
side shields during power tool operation or when
blowing dust. If operation is dusty, also wear a
dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. They contain
chemicals that can damage, weaken, or destroy
plastic.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.
WARNING:
To ensure safety and reliability, all repairs should
be performed by a qualified service technician
at an authorized service center to avoid risk of
personal injury.
CHANGING THE BATTERIES IN THE LASER
See Figure 36.
Unplug the saw.
Rotate and hold lower blade guard up.
Using the hex key (1/16 in.) provided, loosen and remove
the screw from the battery compartment then separate
the cover from the laser guide.
Lower the blade guard.
Remove the three button cell batteries from the battery
compartment.
NOTE: Replace the batteries with button cell batteries
that have a rating of 1.5 volt and 100 mAh (milliampere
hour) minimum (number 76 series or equivalent).
Fig. 36
When replacing the batteries, the laser guide should be
thoroughly cleaned. Use a soft paintbrush, or similar
device, to remove all sawdust and debris.
After cleaning the laser guide and replacing batteries,
align the two slots and secure the battery compartment
to laser guide using the screw. Tighten screw securely.
CAUTION:
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
m
n
NEGATIVE (–)
BATTERIES
BATTERY
COMPARTMENT
SCREW
BATTERY
COMPARTMENT
LASER
GUIDE
SLOT