RIDGID TP1300LS Planer User Manual


 
11
ASSEMBLY
ASSEMBLING LEG STAND
See Figures 5 and 6.
Separate brace pieces from leg pieces. There are a total
of 16 pieces: 8 brace pieces and 8 leg pieces.
Remove the following hardware from the hardware bag:
32 carriage bolts (M8 x 1-1/4 in.)
4 rubber feet
4 hex bolts (M8 x 1-1/4 in. x 65)
4 flat washers
36 flanged hex nuts (M8 x 1-1/4 in.)
Place upper brace, long, inside upper leg piece.
NOTE: Upper brace has two large, oval holes in each
end; these holes should be on top when leg stand is
completely assembled as shown in figure 5.
Align holes on the upper brace with the holes on the leg
piece. Insert two carriage bolts and hand tighten using
hex nuts.
Place lower leg piece inside upper leg brace. Place
lower brace, long, on top of both leg pieces.
Align holes on all three pieces. Insert two carriage bolts
and hand tighten using hex nuts.
Attach a second upper leg piece to the outside of upper
brace using two carriage bolts and hex nuts.
CARRIAGE
BOLT
Next, attach lower leg piece to the inside of upper leg
piece placing lower brace on top of both leg pieces (also
on the inside of the leg stand). Insert two carriage bolts
and hand tighten using hex nuts.
Repeat the above steps once.
This completes two of the four sides of the leg stand.
Place upper brace, short, inside upper leg piece.
NOTE: Upper brace, short, has two large, oval holes in
each end; these holes should be on top when leg stand
is completely assembled.
Align holes on upper brace, long, with the holes on the
upper leg piece. Insert two carriage bolts and hand
tighten using hex nuts.
Repeat the above step on the opposite side.
On the inside of the leg stand, place lower brace, short,
on top of both the upper and lower leg pieces. Insert two
carriage bolts and hand tighten using hex nuts.
Repeat the above step on the opposite side.
Place one rubber foot on the bottom of each lower leg
piece.
Using a wrench, securely tighten all hex nuts.
This completes the leg stand.
RUBBER FOOT
HEX NUT
UPPER BRACE,
SHORT
UPPER LEG
CARRIAGE BOLT
LOWER
BRACE,
LONG
LOWER
BRACE, SHORT
LOWER LEG
UPPER BRACE,
LONG
Fig. 5