Filter
Top Products
1
Repeat
Cut
A
-
-
1
1
1
1
1
3
3
2
2
"
"
4
4
4
4
8
1
1
1
6
5
4
2
1
0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
3
6
5
4
2
1
0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
3
1
Repeat
Cut
A
-
-
1
1
1
1
1
3
3
2
2
"
"
4
4
4
4
8
1
1
1
3
1/8
3/32
1/16
1/32
0
2.5
2
1.5
1
.5
0
Ind
I
Cut
6
5
4
2
1
0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
3
Fig. 12
LEVELING THE TABLE EXTENSIONS
See Figure 11.
The infeed and outfeed table extensions are attached to the
planer. Shipped in a folded, "upright" position, the table
extensions must be in the "down" position before planing can
begin. For accurate planing, table extensions must be level
with the planer table.
NOTE: For optimum performance, always check to make
sure the table extensions are level before beginning planing
operations.
To Level:
Unplug your planer.
WARNING:
Failure to unplug the tool could result in accidental
starting causing possible serious personal injury.
Place a straight edge or level across both the planer
table and table extensions.
If adjustment is necessary, lift table extensions and loosen
lock nuts. Adjust stop screws (one on each side) until
extension table is level with planer table.
Press down on the table extension to ensure the table
extension is properly seated.
Tighten lock nuts securely when adjustments are
complete.
NOTE: Four screws attach table extensions to support
bars; loosening these screws may aid in leveling table
extensions.
BLADE HEIGHT ADJUSTMENT
See Figure 12.
Raising and lowering the depth adjustment handwheel
controls the depth of cut on your planer.
NOTE: Never adjust blade height with cutter lock in the
"locked" position (pushed to the far right).
To Raise:
Push cutter lock to the left to unlock cutter head
assembly.
Turn the depth adjustment handwheel clockwise to the
desired height.
Once the cutter head is in desired position, lock the
cutter head assembly in place by pushing the cutter lock
handle to the right.
To Lower:
Push cutter lock to the left to unlock cutter head
assembly.
Turn the depth adjustment handwheel counterclockwise
to the desired height.
Once cutter head assembly is in the desired position,
lock cutter head in place by pushing cutter lock handle to
the right.
NOTE: Each complete rotation of the handle moves the
cutter head assembly 1/64 in. (1.60 mm).
LOCK NUT
STOP SCREWS
TABLE
EXTENSION
PLANER
TABLE
DEPTH
ADJUSTMENT
HANDWHEEL
STRAIGHT
EDGE
TABLE
EXTENSION
Fig. 11
SURE-
CUT™
14
ASSEMBLY