Filter
Top Products
"%&&$% %
Use the depth guide to adjust the depth of
cut. Loosen the thumb screw by turning it
counter-clockwise until the depth guide can
slide freely to the desired depth of cut (about
1/8” greater than material thickness) and
retighten the thumb screw (clockwise) (Fig.
8). For bits with a guide point, make sure that
the entire guide point tip will extend 1/8”
beyond the material thickness (Fig. 2). For
standard point bits, make sure that the fluted
end of the bit extends 1/8” beyond the
material thickness.
(!#%
Your tool is also equipped with a light that
turns on automatically when the switch is
activated, for better visibility when cutting
(Fig. 1).
1/8"
THUMB
SCREW
FIG. 8
%#! '#$"
! %#!
The electronic speed control feature allows
motor speed to be matched to cutter size and
material hardness for improved finish,
extended bit life, and higher performance.
Speed changes are achieved by rotating
Control Dial UP to increase speed, DOWN to
decrease as indicated on housing (Fig. 7).
Speed may be changed while tool is on. The
reference numbers on the dial facilitate re-
setting control to desired speed.
SPEED
CONTROL DIAL
FIG. 7
-11-
RZ 2610001563 07-09:RZ 2610001563 07-09 7/24/09 10:13 AM Page 11