Filter
Top Products
$0=A4.0
"=0A09?4A08,49?09,9.0
;0=1:=80/-D@9,@?3:=4E0/
;0=>:99078,D=0>@7?4984>;7,.492:1
49?0=9,7B4=0>,9/.:8;:909?>B34.3
.:@7/ .,@>0 >0=4:@> 3,E,=/ We
recommend that all tool service be performed
by a Bosch or Rotozip Factory Service Center
or Authorized Bosch Service Station. Call 1-
877-ROTOZIP (1-877-768-6947) if your tool
needs service.
%!!&#%!
Your Rotozip tool has been properly lubricated
and is ready to use. The lubrication applied at
the factory lasts for the life of the tool.
#! #&$$
The brushes and commutator in your tool have
been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brush es be examined.
Only genuine Rotozip replace ment brushes
specially designed for your tool should be
used.
# $
Your Rotozip tool and attachments contain
sealed bearings designed to last the life of the
tool. Bearings which become noisy (due to
heavy load or very abrasive material cutting)
should be inspected at once to avoid
overheating or motor failure. Contact your local
Bosch or Rotozip Factory Service Center if
your bearings become noisy.
70,9492
%:,A:4/,..4/09?>,7B,D>
/4>.:990.??30?::71=:8
?30 ;:B0= >@;;7D -01:=0 .70,9492 :=
;0=1:=8492,9D8,49?09,9.0 The tool may
be cleaned most effectively with compressed
dry air. 7B,D>B0,=>,10?D2:2270>B309
.70,9492?::7>B4?3.:8;=0>>0/,4=
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
at tempt to clean by inserting pointed objects
through openings.
0=?,49.70,9492,209?>
,9/ >:7A09?> /,8,20
;7,>?4.;,=?> Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents, ammonia and house hold detergents
that contain ammonia.
!
WARNING
,49?09,9.0
&%
1. Your jigsaw handle attachment is
equipped with a trigger switch. Slide the lock-
out lever (figure 7) to either side with your
thumb, then squeeze the trigger.
2. While holding the tool firmly, insert the bit
into the material at a 45° angle (figure 8).
3. Slowly bring it to a 90° angle to begin the
cut. The base plate should be flush to the
material surface (figure 9).
4. Release the trigger to de-activate your tool
after the cut.
!
WARNING
!
CAUTION
-20-
FIG. 8
FIG. 9
FIG. 7
LOCK OUT
LEVER
TRIGGER
RZ 2610001563 07-09:RZ 2610001563 07-09 7/24/09 10:13 AM Page 20