Filter
Top Products
Loosen (2) V4 20 Gib set screws on the left side at the
rear of the column support,
3. Elevate, and then lower the Arm: (a) if the column
binds and elevation is difficult loosen two 5/16 - 18
plated bolts on front side of the column support until
you achieve smooth but firm elevation. (b) If the
column moves side-to-side within the column support,
tighten the two 5/16 -- 18 plated bolts until movement
disappears - elevation should be smooth and firm.
4. Now tighten the (2) Yf, 20 Gib set screws until no
noticeable rotational play exists between Column Tube
and Column Support.
5. Recheck elevation and re-adjust if necessary.
6, Replace Column Support trim.
B ,OH PtArED O
STEP THREE
SQUARING CROSS CUT TRAVEL (CARRIAGE
TRAVELS IN A STRAIGHT LINE).
1. Index but do not lock arm at 0° miter.
2. Install saw blade as shown. Motor shaft has left hand
threads.
NOTE: Do not overtightenarbor nut. Use the arbor wrench
to just "snug" it.
BLADE
ROTATION 1
SHAFT WRENCH
o END OF ARBOR WRENCH
Rf_STING ON TABLE
SAW BLADE _..__
OCTEF_ COLLAR __ iii _._ MOTOR
ARBOR NUT _INNER COLLAR
14